Then, contact Okidata Technical Information for further assistance. MHM drives the line feed motor in two-phase bipolar, based on the phase changeover data output from the LSI. Encoder Disk Encoder Disk As the space motor operates, the encoder disk spins. When shipping the printer, use the original packaging to prevent damage. Make sure the cable from CN1 of the operation panel is properly connected to CN7 on the main control board. The power to the main control board is supplied by the power supply assembly through a wire harness.

Uploader: Samurisar
Date Added: 28 January 2013
File Size: 37.61 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 23517
Price: Free* [*Free Regsitration Required]

Small pieces of paper can cause paper jams. Lift and remove the ribbon. Printhead Operation Printhead Oi Printhead Operation When the printhead is idle, the armature is attracted to the permanent magnet. Page of Go. Gear Case Assembly 3. Serial Cable Information Serial Cable Information Serial Cable Information The micriline in this section will help you make a serial cable to connect between the printer and computer.

Recent Drivers  TOSHIBA TECRA A8-S8514 DRIVER FOR WINDOWS

Is the firmware the latest current revision?

Forms Tear Off 3. In the case of envelopes, where the medium thickness varies as the printhead moves along the platen, the head gap changes to compensate for the differences in thickness. Then, contact Okidata Technical Information for further assistance. Tips For Preventing Image Problems 4. In order to run this test, the serial interface board must be installed with a serial loopback test connector attached to it.

Oki Microline 590 Black Nylon Ribbon

Check the power cord connection to the outlet and to the printer. It is attached to the carriage, which moves parallel to the platen.

The Microline uses both springs. Table of Contents Add to my manuals Add. Uneven print density No line feed operation.

Paper Feed Paths 1. Just before paper is loaded, the printhead moves towards the left bracket and unlatches the support protector.

Okidata Microline Parallel Pin Dot Matrix Impact Printer – Beige

Main RSPL 3. The LSI transmits the print data mjcroline serial data to the logic circuit of the printhead.

The carriage should move smoothly.

Recent Drivers  MEMOREX LIGHTSCRIBE DRIVER

Set the change lever 2 to the bottom feed position toward the rear of the printer. These procedures may be required when replacing either consumables or parts. Parallel Interface Control 2. Disable the menu item Print Suppress if the function is not required. Each Item has several Settings.

Make sure the cable from CN1 of the operation 5900 is properly connected to CN7 on the main control board. Shipping Instructions When ooi the printer, use the original packaging to prevent damage.

Microlnie Initialization occurs as listed below. Sheet RSPL 3. The carriage cable should be detached from the space motor before removing the carriage shaft.

Page 89 Chapter 3 3. Remove the carriage cable. Word processor files do not print the way the MENU and front panel are set. Is it correctly connected?